Radiant Heat Warmers

Radiant Warmer with Trolley

  • Quartz crystal heater with stainless steel reflector.
  • Special spot light for illumination purpose during procedures.
  • Electronic Temp. Indicator & Controller with + 0.2° C accuracy.
  • Special skin sensor for recording Baby's bodies temperature.
  • Digital display of Actual & Set Temp.
  • Over Temp. Cut off audio visual 37.5° C
  • Baby Care Trolley with steel top for easy cleansing & fumigation.
  • Large baby bed, with head low, head high facility.
  • Drop down acrylic side supports for easy access to baby.
  • Baby Care Trolley with one open rack.
  • I.V. Pole support & one I.V. Rod.
  • Indications provided for Heater on, Over Temp., Sensor fail, Check ambient, refer manual

The above model available in Servo Version & also available in S.S. Version.



Servo Diligent Warmer

Diligent modeling of the machine to facilitate placement and movement for maximum convenience.

  • Finely angled Display's and Controls that improves operational dexterity and this maximizes efficiency.

  • An asthetical design & appearance that livens up the ambience of your unit.

  • Intelligent Micro Controlled based Servo Proportionate Controller for Pin Point Temp. Maintenance.

  • Self-Diagnosis of Controller facilities easy detection of error if any.

  • Patient Temp. Can be viewed either in Degree's Centigrade or Degree's Farenhite.

  • Proportionally Controlled heater output with Bargarph Segmented in 4 increments to indicate Exact Heater Status.

  • One side sensing flat skin probe for temp. Accuracy and easy fixation.

  • Temperature section achieved by means of feather touch keys.

  • An Unintrusive horizontally placed quartz crystal heater with steel reflector.

  • Large baby bed in stainless steel for treating even a full term infant, also helps in easy cleansing and fumigation.

  • Vertically movable side supports for easy access to baby.

  • A special spot light is provided to brighten up meticulous procedures.

  • One infusion rod provided with the unit.

The above model also available in Non Servo Version

Technical Details

Length : 685 mm (27 Inch)
Breadth: 711 mm (28 Inch)
Height: 1700 mm (67 Inch)
Weight: 40 Kgs Approx
Baby Bed Size: 711 x 457 mm ( 28 x 18 Inch)
Baby Bed: fabricated Stainless Steel
Tilt: + 8°

Working level from ground: 950 mm
Best environment of operation : 24 to 29° c
Electrical Ratings: 230 VAC +10% 50 Hz
Storage: 2 open compartments in Stainless Steel.
Heater: 2-silicon quartz crystal, 500 Wtts max.
Electronic Controller: Servo proportional or non-servo as per requirement.
Display resolution: 0.1° C




Micro Controlled Proportionate System

Intelligence personified
  • Three level safety system
  • Servo Mode & Manual Mode
  • Baby Temp. Display in degrees centigrade & Fahrenheit
  • Separate display for Set Temp.
  • Bar Graph to indicate heater output
  • Under Temp. Indication
  • Over Temp. Indication & alarm
  • Feed Alarm 3 hourly (automate facility)
  • Apgar Timer incorporated
  • Warmer Usage hour indication
  • Self diagnosis facility


Perfect Duet (JEEWAK)

Combination of Radiant Heat Warmer & Phototherapy Unit

Technical Details

Height

1880 mm ( 74 Inches)

Baby Bed Size

735x480 mm (29"x19")

Monitor Tray Size i) 325 mm x 225 mm ii) 295mmx225mm

Working level

1000 mm from ground

Tilt

+ 8 degrees

Side Supports

Acrylic Drop Down Type

Electrical Rating

230 VAC + 10% 50 Hz

Observation Lamp

Halogen (12 Volt, 24 Walts)

Heater Wattage

650 Watts

Heater Type

Ceramic / Quartz crystal

Electronic Controller

Micro Controller based servo proportionate control with feather touch keys for temp setting.

Display

3 Digit Green LED for indicating set temp, Apgar time.
4 Digit Green LED for indicating baby's actual temp. in ° C & ° F

Alarms

Over Temp., 2nd Safety active, Sensor fail, 3rd Safety active, Apgar time, Feed time.

Best environment for operation

22 to 28 degrees

 

Accessories at extra Cost-

  1. Cage to hold oxygen cylinder.
  2. Neovac slow suction. (electrically or venturi operated)
  3. Manometer, Humidifying bottle with flow meter.
  4. Resuscitation Kit.
  5. Air Oxygen blender.

 




About us                 |             Product Range                  |            Enquiry Form                    |             Contact            |             Home